2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Aug 2013

HINT:
  1. When using the intelligent tester with the ignition switch off to troubleshoot: Connect the intelligent tester to the vehicle and turn the front door courtesy light switch LH (for LHD) or RH (for RHD) on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.
  2. Refer to the intelligent tester operator's manual for further details.


CHECK FOR IMMOBILISER DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Immobiliser / DTC.

  5. Check for DTCs.


CHECK FOR ECM DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Powertrain / Engine and ECT / DTC.

  5. Check for DTCs.


CLEAR IMMOBILISER DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Immobiliser / DTC.

  5. Clear the DTCs.


CLEAR ECM DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Powertrain / Engine and ECT / DTC.

  5. Clear the DTCs.

← TERMINALS OF ECU (from Aug 2013)DATA LIST / ACTIVE TEST (from Aug 2013) →