2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

B2793 Transponder Chip Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2013

Also covers:

DESCRIPTION

  1. DTC B2793 is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if key code registration cannot be performed normally and this DTC is output.
  2. DTC B2794 is stored when a key with an incomplete key code is inserted into the ignition key cylinder.
  3. DTC B2795 is stored when a key with a key code that is not registered in the ECU is inserted into the ignition key cylinder.
DTC Code
DTC Detection Condition
Trouble Area
B2793
A transponder chip malfunction.
Key
B2794
A key with an incomplete key code is inserted into the ignition key cylinder.
B2795
A key with an unregistered key code is inserted into the ignition key cylinder.

INSPECTION PROCEDURE

NOTICE:
When the key is replaced, refer to the Service Bulletin.


1. RE-REGISTER KEY
  1. Clear the DTCs (Click here).

  1. Re-register the key code with the transponder key ECU assembly (Refer to the Service Bulletin).

  1. Check that the engine starts with the key.

    OK:
    Engine starts.



NG
REPLACE KEY
OK

END


← B2784 Antenna Coil Open / Short (from Aug 2013)B2796 No Communication in Immobiliser System (+ B2798) (from Aug 2013) →