2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
  1. Remove the exhaust manifold sub-assembly LH (Click here).


3. REMOVE STARTER COVER

  1. A222904
    Remove the 3 bolts and starter cover.


4. REMOVE STARTER ASSEMBLY

  1. A222905
    Remove the bolt and disconnect the ground wire.

  1. Disconnect the starter connector.

  1. Open the terminal cap.

  1. Remove the nut and bolt, and then disconnect the starter wire.

  1. A218197
    Remove the 2 bolts and starter assembly.


5. REMOVE FLYWHEEL HOUSING SIDE COVER

A222907
← REMOVAL (Aug 2013 – Jul 2014)DISASSEMBLY (from Aug 2013) →