INSTALLATION
Removal / installation · Vehicles built from Aug 2013
| 1. INSTALL BACK DOOR HINGE ASSEMBLY LH |
- HINT:
- Perform the following procedures if replacing the back door hinge assembly LH.
Using a T30 "TORX" socket wrench, install the back door hinge with the 2 screws.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
| 2. INSTALL BACK DOOR HINGE ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
| 3. INSTALL BACK WINDOW GLASS SPACER |
- HINT:
- Perform the following procedures if replacing any back window glass spacer.


| *1 |
No. 2 Back Window Glass Spacer |
*2 |
No. 1 Back Window Glass Spacer |
Apply Primer G to the window where the spacer will be installed.
- Standard:
Area
Specified Condition
a
88.2 mm (3.47 in.)
b
100.7 mm (3.94 in.)
c
73.7 mm (2.90 in.)
d
35.0 mm (1.37 in.)
- NOTICE:
- Allow the primer to dry for 3 minutes or more.
- Throw away any leftover primer.
- Do not apply too much primer.
- Allow the primer to dry for 3 minutes or more.
- HINT:
- If the primer is applied to an area that is not specified, apply non-residue solvent to a clean cloth and wipe off the excess primer before it dries.
Remove the peeling paper from a new spacer install the spacer to the back door glass at the location shown in the illustration.
| 4. INSTALL BACK WINDOW LOCK STRIKER ASSEMBLY |
Install the lock striker with the 2 nuts.
| 5. INSTALL BACK DOOR LOCK STRIKER COVER |
Attach the 3 claws to install the lock striker cover.
| 6. INSTALL BACK DOOR GLASS |
Install the back door glass with the 4 bolts.
- Torque:
- 20 N*m{ 204 kgf*cm , 15 ft.*lbf }
Attach the 2 clamps and install the connector.
| 7. INSTALL BACK WINDOW STAY ASSEMBLY LH |
Install the 2 stop rings to the back door stay assembly.
Install the back window stay assembly.

- CAUTION:
- Install the back window stay while supporting the back door glass by hand.
Check that the back window stay is attached to the ball joint and cannot be pulled off.
| 8. INSTALL BACK WINDOW STAY ASSEMBLY RH |
- HINT:
- Use the same procedures described for the LH side.
| 9. INSTALL REAR WIPER MOTOR ASSEMBLY |
| 10. INSTALL REAR WIPER ARM |
| 11. INSTALL REAR SPOILER SUB-ASSEMBLY |
w/o Back Door Tire Carrier:
Install the rear spoiler sub-assembly (Click here).
w/ Back Door Tire Carrier:
Install the rear spoiler sub-assembly (Click here).
| 12. INSTALL REAR SPOILER COVER RH |
Attach the 2 clips to install the rear spoiler cover.
| 13. INSTALL REAR NO. 1 SPOILER COVER |
Attach the 5 clips and fastening tape to install the rear No. 1 spoiler cover.
