B1422 Compressor Lock Sensor Circuit
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
SYSTEM DESCRIPTION
The ECM sends the engine speed signal to the air conditioning amplifier assembly via CAN communication.The air conditioning amplifier assembly reads the difference between compressor speed and engine speed. When the difference becomes too large, the air conditioning amplifier assembly determines that the cooler compressor assembly is locked and turns the magnet clutch assembly off.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1422 |
Open or short in the compressor lock sensor circuit. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- As DTC B1422 is also output when the compressor drive belt is damaged or loose, inspect the belt before performing troubleshooting.
| 1. CHECK CAN COMMUNICATION SYSTEM |
Use the intelligent tester to check if the CAN communication system is functioning normally.
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output (for LHD with Entry and Start System)
B
CAN DTC is output (for LHD without Entry and Start System)
C
CAN DTC is output (for RHD with Entry and Start System)
D
CAN DTC is output (for RHD without Entry and Start System)
E
|
|
||||
|
|
||||
|
|
||||
|
|
||||
| A | |
| 2. INSPECT COOLER COMPRESSOR ASSEMBLY (A/C LOCK SENSOR) |
for 1GR-FE:Remove the cooler compressor assembly (A/C lock sensor) (Click here).

for 1KD-FTV:Remove the cooler compressor assembly (A/C lock sensor) (Click here).
for 2TR-FE:Remove the cooler compressor assembly (A/C lock sensor) (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 (SSR+) - 2 (SSR-)
20°C (68°F)
160 to 320 Ω
Result Result
Proceed to
OK
A
NG (for 1GR-FE)
B
NG (for 1KD-FTV)
C
NG (for 2TR-FE)
D
|
|
||||
|
|
||||
|
|
||||
| A | |
| 3. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - A/C LOCK SENSOR) |
Disconnect the G25 amplifier connector.
Disconnect the C39 sensor connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G25-8 (LOCK) - C39-1 (SSR+)
Always
Below 1 Ω
G25-13 (SG-2) - C39-2 (SSR-)
Always
Below 1 Ω
G25-8 (LOCK) - Body ground
Always
10 kΩ or higher
G25-13 (SG-2) - Body ground
Always
10 kΩ or higher
Result Result
Proceed to
OK (When troubleshooting according to problem symptoms table)
A
OK (When troubleshooting according to the DTC)
B
NG
C
|
|
||||
|
|
||||
| A | ||
| ||
