2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

B1419/19 Rear Room Temperature Sensor Circuit

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The cooler thermistor (rear room temperature sensor) is installed in the rear panel. It detects the rear cabin temperature to control the air conditioning AUTO mode. The resistance of the cooler thermistor (rear room temperature sensor) changes in accordance with the rear cabin temperature. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.
The air conditioning amplifier assembly applies a voltage (5 V) to the cooler thermistor (rear room temperature sensor) and reads voltage changes as the resistance of the cooler thermistor (rear room temperature sensor) changes.
DTC Code
DTC Detection Condition
Trouble Area
B1419/19
Open or short in the cooler thermistor (rear room temperature sensor) circuit.
  1. Cooler thermistor (rear room temperature sensor)
  2. Harness or connector
  3. Air conditioning amplifier assembly

WIRING DIAGRAM

E156584E70

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (REAR ROOM TEMPERATURE SENSOR)
  1. Use the Data List to check if the rear room temperature sensor is functioning properly (Click here).

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Room Temp Sensor (Rear)
    Cooler thermistor (rear room temperature sensor) /
    Min.: -6.5°C (20.3°F)
    Max.: 57.25°C (135.05°F)
    Actual rear cabin temperature displayed
    Open in the circuit: -6.5°C (- 20.3°F).
    Short in the circuit: 57.25°C (135.05°F).

    OK:
    The display is as specified in the normal condition column.

    Result 
    Result
    Proceed to
    OK (When troubleshooting according to problem symptoms table)
    A
    OK (When troubleshooting according to the DTC)
    B
    NG
    C



B
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)

C
Go to step 2
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT COOLER THERMISTOR (REAR ROOM TEMPERATURE SENSOR)

  1. E193113E02
    Remove the cooler thermistor (rear room temperature sensor) (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    10°C (50°F)
    3.00 to 3.73 kΩ
    15°C (59°F)
    2.45 to 2.88 kΩ
    20°C (68°F)
    1.95 to 2.30 kΩ
    25°C (77°F)
    1.60 to 1.80 kΩ
    30°C (86°F)
    1.28 to 1.47 kΩ
    35°C (95°F)
    1.00 to 1.22 kΩ
    40°C (104°F)
    0.80 to 1.00 kΩ
    45°C (113°F)
    0.65 to 0.85 kΩ
    50°C (122°F)
    0.50 to 0.70 kΩ
    55°C (131°F)
    0.44 to 0.60 kΩ
    60°C (140°F)
    0.36 to 0.50 kΩ

    Text in Illustration 
    *a
    Resistance
    *b
    Allowable Range
    *c
    Temperature

    NOTICE:
    1. Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
    2. When measuring, the sensor temperature must be the same as the ambient temperature.

    HINT:
    As the temperature increases, the resistance decreases (refer to the graph).



NG
REPLACE COOLER THERMISTOR (REAR ROOM TEMPERATURE SENSOR) (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (REAR ROOM TEMPERATURE SENSOR - AIR CONDITIONING AMPLIFIER)
  1. Disconnect the G24 amplifier connector.

  1. Disconnect the Q19 sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Q19-1 - G24-17 (TR)
    Always
    Below 1 Ω
    Q19-2 - G24-7 (SG-6)
    Always
    Below 1 Ω
    Q19-1 - Body ground
    Always
    10 kΩ or higher
    Q19-2 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)


← B1417/17 Rear Evaporator Temperature Sensor Circuit (from Aug 2014)B1419/19 Rear Room Temperature Sensor Circuit (from Aug 2014) →