Microphone Circuit between Microphone and Navigation Receiver Assembly
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This circuit sends a microphone signal from the telephone microphone assembly to the navigation receiver assembly.It also supplies power from the navigation receiver assembly to the telephone microphone assembly.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK NAVIGATION RECEIVER ASSEMBLY |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
H61-19 (MIN-) - Body ground
Always
Below 1 Ω
H61-18 (SGND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
H61-4 (MACC) - Body ground
Engine switch on (ACC)
4.75 to 5.25 V
Text in Illustration *a
Component with harness connected
(Navigation Receiver Assembly)
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY) |
Disconnect the H61 navigation receiver assembly connector.
Disconnect the W7 roof console box assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H61-4 (MACC) - W7-11 (MACC)
Always
Below 1 Ω
H61-5 (MIN+) - W7-12 (MCO+)
Always
Below 1 Ω
H61-19 (MIN-) - W7-13 (MCO-)
Always
Below 1 Ω
H61-6 (SNS2) - W7-14 (SNS2)
Always
Below 1 Ω
H61-4 (MACC) - Body ground
Always
10 kΩ or higher
H61-5 (MIN+) - Body ground
Always
10 kΩ or higher
H61-19 (MIN-) - Body ground
Always
10 kΩ or higher
H61-18 (SGND) - Body ground
Always
10 kΩ or higher
H61-6 (SNS2) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK TELEPHONE MICROPHONE ASSEMBLY |
Replace the telephone microphone assembly with a known good one (Click here).
Check if the same problem occurs again.
- OK:
- Malfunction disappears.
|
|
||||
| OK | ||
| ||
