2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Display Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM

E286235E03

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the H61 navigation receiver assembly connector.

  1. Disconnect the H68 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H61-13 (VV+) - H68-6 (VV+)
    Always
    Below 1 Ω
    H61-14 (VV-) - H68-11 (VV-)
    Always
    Below 1 Ω
    H61-13 (VV+) - Body ground
    Always
    10 kΩ or higher
    H61-14 (VV-) - Body ground
    Always
    10 kΩ or higher
    H61-12 (SG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Microphone Circuit between Microphone and Navigation Receiver Assembly (from Aug 2014)Display Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter (from Aug 2014) →