2013-2015 Land Cruiser Prado · Service Manual Steering

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

NOTICE:
  1. When using a vise, do not overtighten it.
  2. When installing the parts indicated by arrows, coat them with power steering fluid (Click here).


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT WHEEL RH

3. REMOVE FRONT FENDER APRON SEAL RH

  1. A223336
    Remove the 4 clips and fender apron seal.


4. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A229925E01
    Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
    Text in Illustration 
    *1
    Pin
    *2
    Hook


5. REMOVE AIR CLEANER CAP AND HOSE

  1. A224721
    Remove the air cleaner cap and hose.

    1. Disconnect the mass air flow meter connector, vacuum hose and ventilation hose and detach the 4 clamps.

    2. Loosen the clamp.

    3. Unfasten the 4 hook clamps, and then remove the bolt and air cleaner cap and hose.


6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

7. REMOVE AIR CLEANER CASE

8. REMOVE FAN AND GENERATOR V BELT

  1. A217571
    While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ 6 mm (0.236 in.) into the service hole to fix the belt tensioner in place.

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the V belt.


9. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR

  1. C215461
    Disconnect the 2 connectors.


10. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

  1. C215462
    Slide the clip and disconnect the oil reservoir to pump hose from the vane pump.


11. DISCONNECT PRESSURE FEED TUBE

  1. C215463
    Remove the union bolt and disconnect the pressure feed tube.

  1. Remove the gasket.


12. REMOVE VANE PUMP ASSEMBLY

  1. C216288
    Remove the bolt and harness bracket.

  1. C216289
    Remove the 2 bolts and vane pump.

← REMOVAL (Aug 2013 – Jul 2014)DISASSEMBLY (from Aug 2013) →