2013-2015 Land Cruiser Prado · Service Manual Drivetrain

P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The TCM detects the signal from the transfer L4 position switch.
This DTC indicates that the transfer L4 position switch remains on.
DTC Code
DTC Detection Condition
Trouble Area
P2772
Transfer L4 position switch remains on while the vehicle is being driven under the following conditions for 1.8 sec. or more (1-trip detection logic):
(a) Output shaft speed is between 1000 and 3000 rpm.
(b) Transfer is in H4.
  1. Short in transfer L4 position switch circuit
  2. Transfer system
  3. TCM

MONITOR DESCRIPTION

The TCM monitors the transfer-case L4 position switch to determine when the transfer-case L4 gears are engaged. If the L4 position switch indicates that the transfer-case L4 gears are engaged under the following conditions, the TCM will conclude that there is a malfunction of the L4 position switch, illuminate the MIL and store the DTC:
  1. The transfer-case shifter is in the "H4" position.
  2. The transfer-case output shaft speed is between 1000 and 3000 rpm.
  3. The specified time period has elapsed.

WIRING DIAGRAM

C214970E04

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND)

  1. C209926E12
    Disconnect the G53 four wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G53-21 (L4) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Four Wheel Drive Control ECU)



NG
Go to step 2
OK

GO TO TRANSFER SYSTEM (Click here)

2. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - TCM)

  1. C212048E03
    Disconnect the G71 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G71-15 (L4) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to TCM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM (Click here)


← P2759 Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical (Shift Solenoid Valve SLU) (from Aug 2014)P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance (from Aug 2014) →