2013-2015 Land Cruiser Prado · Service Manual Suspension

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT ABSORBER CONTROL ACTUATOR

  1. C214842E02
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH 
    Tester Connection
    Condition
    Specified Condition
    1 (FAL+) - 2 (FAL-)
    Always
    6.4 to 7.2 Ω
    3 (FBL+) - 4 (FBL-)
    6.4 to 7.2 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Absorber Control Actuator LH)
    If the result is not as specified, replace the absorber control actuator.

  1. C214842E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for RH 
    Tester Connection
    Condition
    Specified Condition
    1 (FAR+) - 2 (FAR-)
    Always
    6.4 to 7.2 Ω
    3 (FBR+) - 4 (FBR-)
    6.4 to 7.2 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Absorber Control Actuator RH)
    If the result is not as specified, replace the absorber control actuator.

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →