2013-2015 Land Cruiser Prado · Service Manual Power Source / Network

U0208 Lost Communication with "Seat Control Module A"

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
U0208
There is no communication from the front power seat switch RH.
  1. Power source or inside front power seat switch RH
  2. Front power seat switch RH CAN branch wire or connector
  3. Front power seat switch RH
  1. For vehicles with a seat position memory.

WIRING DIAGRAM

C185571E09

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Operating the engine switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAB main wire and the CAN branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the airbag system.

    NOTICE:
    1. After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
    2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (FRONT POWER SEAT SWITCH RH CAN BRANCH WIRE)

  1. C210038E01
    Disconnect the a5 front power seat switch RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    a5-8 (CANP) - a5-7 (CANN)
    Engine switch off
    54 to 69 Ω

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to Front Power Seat Switch RH)



NG
REPAIR OR REPLACE FRONT POWER SEAT SWITCH RH CAN BRANCH WIRE OR CONNECTOR (CANP, CANN)
OK


3. CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT SWITCH RH - BATTERY AND BODY GROUND)

  1. C210046E01
    Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect the a4 front power seat switch RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    a4-2 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    a4-7 (+B) - Body ground
    Always
    11 to 14 V
    a5-12 (SYSB) - Body ground
    Always
    11 to 14 V

Text in Illustration 
*a
Rear view of wire harness connector
(to Front Power Seat Switch RH)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE FRONT POWER SEAT SWITCH RH (Click here)


← U0208 Lost Communication with "Seat Control Module A" (Aug 2013 – Jul 2014)U0233 Lost Communication with Blind Spot Monitor Master Module (Aug 2013 – Jul 2014) →