2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

B2769 Tilt Sensor Signal Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The yaw rate sensor assembly conducts a self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).
If a malfunction is detected in the CSIF-GCS line, the main body ECU stores DTC B2769.
DTC B276A is stored when terminal CSIF of the yaw rate sensor assembly has not received a signal for 5 seconds or more.
DTC Code
DTC Detection Condition
Trouble Area
B2769
After a normal/trouble signal is output from the yaw rate sensor assembly as a result of self-diagnosis, following malfunctions are detected:
  1. The CSIF-GCS line circuit is open.
  2. Reception of signals other than a normal/trouble signal.
  1. Yaw rate sensor assembly
  2. Main body ECU
  3. Harness or connector
B276A
Terminal CSIF of the yaw rate sensor assembly has not received a signal for 5 seconds or more.
  1. Yaw rate sensor assembly
  2. Main body ECU
  3. Harness or connector

WIRING DIAGRAM

B224123E03

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate sensor assembly, perform zero point calibration.
  1. Vehicle stability control system (for Hydraulic Brake Booster) (Click here).
  2. Vehicle stability control system (for Vacuum Brake Booster) (Click here).


1. CHECK HARNESS AND CONNECTOR (YAW RATE SENSOR - MAIN BODY ECU)
  1. Disconnect the G52 sensor connector.

  1. Disconnect the G63 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G52-5 (CSIF) - G63-6 (GCS)
    Always
    Below 1 Ω
    G52-5 (CSIF) or G63-6 (GCS) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. REPLACE YAW RATE SENSOR ASSEMBLY
  1. Temporarily replace the yaw rate sensor assembly with a new or normally functioning one (Click here).


NEXT


3. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to ON, and then off.

  1. Set the theft deterrent system to the armed state (Click here).

  1. Check that the security indicator light changes from illuminated to flashing.

  1. Set the theft deterrent system to the disarmed state (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC B2769 or B276A is not output.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

END (YAW RATE SENSOR ASSEMBLY IS DEFECTIVE)


← B2769 Tilt Sensor Signal Circuit Malfunction (+ B276A) (Aug 2013 – Jul 2014)Engine Hood Courtesy Switch Circuit (Aug 2013 – Jul 2014) →