2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

Engine Hood Courtesy Switch Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

  1. The security courtesy switch is built into the hood lock. This switch turns on when the engine hood is opened and turns off when the engine hood is closed.

WIRING DIAGRAM

B240857E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (SECURITY COURTESY SWITCH)
  1. Using the intelligent tester, read the Data List (Click here).

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Hood Courtesy SW
    Security courtesy switch /
    ON or OFF
    ON: Engine hood open
    OFF: Engine hood closed
    -

    OK:
    ON (engine hood open) and OFF (engine hood closed) appear on screen according to condition of engine hood.



NG
Go to step 4
OK


2. INSPECT SECURITY COURTESY SWITCH

  1. B238373
    Disconnect the A27 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2 - 3
    Always
    Below 1 Ω



NG
REPLACE SECURITY COURTESY SWITCH (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (SECURITY COURTESY SWITCH - MAIN BODY ECU AND BODY GROUND)
  1. Disconnect the A27 switch connector.

  1. Disconnect the G64 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-2 - G64-12 (HD2)
    Always
    Below 1 Ω
    A27-3 - Body ground
    Always
    Below 1 Ω
    A27-2 or G64-12 (HD2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

4. INSPECT SECURITY COURTESY SWITCH

  1. B238373
    Disconnect the A27 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 4
    Unlock position
    Below 1 Ω
    1 - 4
    Lock position
    10 kΩ or higher



NG
REPLACE SECURITY COURTESY SWITCH (Click here)
OK


5. CHECK HARNESS AND CONNECTOR (SECURITY COURTESY SWITCH - MAIN BODY ECU AND BODY GROUND)
  1. Disconnect the A27 switch connector.

  1. Remove the main body ECU (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-1 - A-20 (HCTY)
    Always
    Below 1 Ω
    A27-4 - Body ground
    Always
    Below 1 Ω
    A27-1 or A-20 (HCTY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)


← B2769 Tilt Sensor Signal Circuit Malfunction (+ B276A) (from Aug 2014)Engine Hood Courtesy Switch Circuit (from Aug 2014) →