2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY
  1. Install the transmission floor shift with the 4 bolts. Tighten the bolts equally.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. Connect the connector.


2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

C214912
  1. Connect the transmission control cable to the shift lever retainer, and install a new clip.

  1. C214910E01
    Connect the control cable end to the shift lever.

    NOTICE:
    Make sure to connect the cable end so that the inner cable is not twisted. Confirm that the ridged side of the cable end is facing upward.

    Text in Illustration 
    *1
    Ridged


3. ADJUST SHIFT LEVER POSITION
  1. Remove the rear console box (Click here).

  1. w/ Refrigerated Cool Box:
    Remove the rear console box (Click here).

  1. Move the shift lever to N.

  1. C214920
    Loosen the nut of the control cable end.

  1. While pushing the control cable slightly toward the rear side of the vehicle, tighten the nut.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. Move the shift lever and check that there is less wobble when moving the shift lever from N to D than when moving the shift lever to P.

  1. Install the rear console box (Click here).

  1. w/ Refrigerated Cool Box:
    Install the rear console box (Click here).


4. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from P to R with the ignition switch to ON and the brake pedal depressed, make sure that it moves smoothly and correctly into position.

  1. Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to L.

  1. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves in reverse after moving the shift lever to R.
    If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the transmission floor shift assembly installation condition.
    If the indicator and shift lever position do not match, carry out the following adjustment procedures.


5. INSTALL REAR CONSOLE BOX ASSEMBLY
  1. Install the rear console box (Click here).

  1. w/ Refrigerated Cool Box:
    Install the rear console box (Click here).

← ADJUSTMENT (from Aug 2013)INSTALLATION (from Aug 2014) →