2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Video Terminal and Television Display

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This is the sound signal circuit from the video (video adapter) terminal to the television display assembly.

WIRING DIAGRAM

E284347E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - VIDEO [VIDEO ADAPTER] TERMINAL)
  1. Disconnect the W14 television display assembly connector.

  1. Disconnect the T1 video (video adapter) terminal connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    W14-18 (ADPI) - T1-8 (ADPG)
    Always
    Below 1 Ω
    W14-19 (SGN3) - T1-3 (VA-)
    Always
    Below 1 Ω
    W14-20 (L+) - T1-2 (VAL+)
    Always
    Below 1 Ω
    W14-21 (SNG6) - T1-7 (SG)
    Always
    Below 1 Ω
    W14-22 (R+) - T1-1 (VAR+)
    Always
    Below 1 Ω
    W14-18 (ADPI) - Body ground
    Always
    10 kΩ or higher
    W14-19 (SGN3) - Body ground
    Always
    10 kΩ or higher
    W14-20 (L+) - Body ground
    Always
    10 kΩ or higher
    W14-21 (SNG6) - Body ground
    Always
    10 kΩ or higher
    W14-22 (R+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK VIDEO (VIDEO ADAPTER) TERMINAL

  1. E150833E15
    Remove the video (video adapter) terminal connector still connected (Click here).

  1. Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions as shown in the table below.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    T1-1 (VAR+) - Body ground
    External device playing, sound being produced
    Waveform synchronized with sound is output
    T1-2 (VAL+) - Body ground

    Text in Illustration 
    *a
    Component with harness connected
    (Video [Video Adapter] Terminal)



NG
REPLACE VIDEO (VIDEO ADAPTER) TERMINAL (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Radio Receiver and Television Display Assembly (from Aug 2014)Sound Signal Circuit between Video Terminal and Television Display (from Aug 2014) →