Sound Signal Circuit between Video Terminal and Television Display
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This is the sound signal circuit from the video (video adapter) terminal to the television display assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - VIDEO [VIDEO ADAPTER] TERMINAL) |
Disconnect the W14 television display assembly connector.
Disconnect the T1 video (video adapter) terminal connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
W14-18 (ADPI) - T1-8 (ADPG)
Always
Below 1 Ω
W14-19 (SGN3) - T1-3 (VA-)
Always
Below 1 Ω
W14-20 (L+) - T1-2 (VAL+)
Always
Below 1 Ω
W14-21 (SNG6) - T1-7 (SG)
Always
Below 1 Ω
W14-22 (R+) - T1-1 (VAR+)
Always
Below 1 Ω
W14-18 (ADPI) - Body ground
Always
10 kΩ or higher
W14-19 (SGN3) - Body ground
Always
10 kΩ or higher
W14-20 (L+) - Body ground
Always
10 kΩ or higher
W14-21 (SNG6) - Body ground
Always
10 kΩ or higher
W14-22 (R+) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK VIDEO (VIDEO ADAPTER) TERMINAL |
Remove the video (video adapter) terminal connector still connected (Click here).

Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions as shown in the table below.
- Standard:
Tester Connection
Condition
Specified Condition
T1-1 (VAR+) - Body ground
External device playing, sound being produced
Waveform synchronized with sound is output
T1-2 (VAL+) - Body ground
Text in Illustration *a
Component with harness connected
(Video [Video Adapter] Terminal)
|
|
||||
| OK | ||
| ||
