2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Radio Receiver and Television Display Assembly

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The television display assembly sends the sound signal to the radio and display receiver assembly through this circuit.
The sound signal that has been sent sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.

WIRING DIAGRAM

E284346E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
  1. Disconnect the H52 radio and display receiver assembly connector.

  1. Disconnect the W14 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H52-2 (CDR+) - W14-9 (R1+)
    Always
    Below 1 Ω
    H52-3 (CDR-) - W14-10 (R1-)
    Always
    Below 1 Ω
    H52-4 (CDL+) - W14-7 (L1+)
    Always
    Below 1 Ω
    H52-5 (CDL-) - W14-8 (L1-)
    Always
    Below 1 Ω
    W14-11 (SLD1) - Body ground
    Always
    10 kΩ or higher
    H52-2 (CDR+) - Body ground
    Always
    10 kΩ or higher
    H52-3 (CDR-) - Body ground
    Always
    10 kΩ or higher
    H52-4 (CDL+) - Body ground
    Always
    10 kΩ or higher
    H52-5 (CDL-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Radio Receiver and Television Display Assembly (Aug 2013 – Jul 2014)Sound Signal Circuit between Video Terminal and Television Display (Aug 2013 – Jul 2014) →