TERMINALS OF ECU
System information · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| PARKING ASSIST ECU |


Disconnect the I6 and I7 parking assist ECU connectors.
Measure the voltage and resistance according to the value(s) in the table below.
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
I6-1 (+B) - I6-4 (GND1)
L - W-B
Power source signal
Always
10 to 16 V
I6-4 (GND1) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
I6-8 (IG) - I6-4 (GND1)
L - W-B
IG power source signal
Engine switch on (IG)
10 to 16 V
Engine switch off
Below 1 V
I6-9 (ACC) - I6-4 (GND1)
P - W-B
ACC power source signal
Engine switch on (ACC)
10 to 16 V
Engine switch off
Below 1 V
I7-8 (BLSW) - I6-4 (GND1)
L - W-B
Front and side monitor main switch power source signal
Engine switch on (IG), front and side monitor main switch on
10 to 16 V
Reconnect the I6 and I7 parking assist ECU connectors.
Measure the voltage, resistance and waveform according to the value(s) in the table below.
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
I6-10 (TX-)
LG
AVC-LAN communication signal
-
-
I6-11 (TX+)
L
AVC-LAN communication signal
-
-
I7-15 (CV+) - I7-37 (CGND)
R - GR
Rear television camera display signal input
Engine switch on (IG), camera lens not covered, displaying image
Pulse generation (See waveform 1)
Engine switch on (IG), camera lens covered, blacking out screen
Pulse generation (See waveform 2)
I7-14 (CB+) - I7-37 (CGND)
B - GR
Power source to rear television camera
Engine switch on (IG)
5.5 to 7.05 V
I7-27 (REV) - I6-4 (GND1)
R - W-B
Reverse signal
Engine switch on (IG), shift lever in R
7.5 to 14 V
Engine switch on (IG), shift lever not in R
Below 1 V
I7-37 (CGND) - I6-4 (GND1)
GR - W-B
Rear television camera ground (shield)
Always
Below 1 Ω
I7-38 (CV-) - I7-37 (CGND)
W - GR
Rear television camera ground
Always
Below 1 V
Using an oscilloscope, check waveform.

Text in Illustration *a
Waveform 1
*b
Waveform 2
*c
Synchronized Signal
*d
Video Waveform
- HINT:
- The video waveform changes according to the image sent by the rear television camera assembly.
Waveform 1
Measurement Condition Item
Content
Terminal No. (Symbol)
I7-15 (CV+) - I7-37 (CGND)
Tool Setting
200 mV/DIV., 50 μsec./DIV.
Condition
Engine switch on (IG), camera lens is not covered, displaying an image.
Waveform 2
Measurement Condition Item
Content
Terminal No. (Symbol)
I7-15 (CV+) - I7-37 (CGND)
Tool Setting
200 mV/DIV., 50 μsec./DIV.
Condition
Engine switch on (IG), camera lens is covered, blacking out the screen.
| NAVIGATION RECEIVER ASSEMBLY (for Navigation Receiver Type) (Click here) |
| RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type) (Click here) |
| MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here) |