C1622 Open or Short Circuit in Back Camera Signal
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This DTC is stored if the parking assist ECU judges as a result of its self check that the signals or signal lines between the parking assist ECU and the rear television camera assembly are not normal.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1622 |
An open or short in the rear television camera signal circuit |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When "System initializing" is displayed on the parking assist ECU after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
- When "System initializing" is displayed on the parking assist ECU after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
| 1. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR TELEVISION CAMERA ASSEMBLY AND BODY GROUND) |
Disconnect the I7 parking assist ECU connector.
Disconnect the X9*1 or v2*2 rear television camera assembly connector.
- *1: w/ Tire Carrier
- *2: w/o Tire Carrier
- *1: w/ Tire Carrier
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
w/ Tire Carrier Tester Connection
Condition
Specified Condition
I7-38 (CV-) - X9-2 (CV-)
Always
Below 1 Ω
I7-15 (CV+) - X9-3 (CV+)
Always
Below 1 Ω
I7-14 (CB+) - X9-6 (CB+)
Always
Below 1 Ω
I7-37 (CGND) - X9-5 (CGND)
Always
Below 1 Ω
I7-38 (CV-) - Body ground
Always
10 kΩ or higher
I7-15 (CV+) - Body ground
Always
10 kΩ or higher
I7-14 (CB+) - Body ground
Always
10 kΩ or higher
I7-37 (CGND) - Body ground
Always
10 kΩ or higher
w/o Tire Carrier Tester Connection
Condition
Specified Condition
I7-38 (CV-) - v2-2 (CV-)
Always
Below 1 Ω
I7-15 (CV+) - v2-3 (CV+)
Always
Below 1 Ω
I7-14 (CB+) - v2-6 (CB+)
Always
Below 1 Ω
I7-37 (CGND) - v2-5 (CGND)
Always
Below 1 Ω
I7-38 (CV-) - Body ground
Always
10 kΩ or higher
I7-15 (CV+) - Body ground
Always
10 kΩ or higher
I7-14 (CB+) - Body ground
Always
10 kΩ or higher
I7-37 (CGND) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK PARKING ASSIST ECU (CB+, CGND) |
Reconnect the I7 parking assist ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
I7-37 (CGND) - Body ground
Always
Below 1 Ω
I7-38 (CV-) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
I7-14 (CB+) - Body ground
Engine switch on (IG)
5.5 to 7.05 V
| *a |
Component with harness connected (Parking Assist ECU) |
| Proceed to |
Result |
| OK |
A |
| NG (for LHD) |
B |
| NG (for RHD) |
C |
|
|
||||
|
|
||||
| A | |
| 3. CHECK REAR TELEVISION CAMERA ASSEMBLY (CV+, CGND) |


| *a |
Component with harness connected (Parking Assist ECU) |
*b |
Waveform A |
| *c |
Waveform B |
*d |
Synchronized Signal |
| *e |
Video Waveform |
- |
- |
Check the waveform of the rear television camera assembly using an oscilloscope.
- HINT:
- A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the navigation receiver assembly*1 or radio and display receiver assembly*2 with the connector connected.
- *1: for Navigation Receiver Type
- *2: for Radio and Display Type
- The video waveform changes according to the image sent by the rear television camera assembly.
- A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the navigation receiver assembly*1 or radio and display receiver assembly*2 with the connector connected.
Item
Content
Terminal No. (Symbol)
I7-15 (CV+) - I7-37 (CGND)
Tool Setting
200 mV/DIV., 50 μsec./DIV.
Condition
- Waveform A: Engine switch on (IG), camera lens is not covered, displaying an image
- Waveform B: Engine switch on (IG), camera lens is covered, blacking out the screen
- OK:
- Waveform is as shown in the illustration.
| Proceed to |
Result |
| OK (for LHD) |
A |
| OK (for RHD) |
B |
| NG (w/ Tire Carrier) |
C |
| NG (w/o Tire Carrier) |
D |
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
