2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1626 Steering Angle Sensor Failure

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored if the navigation receiver assembly receives a signal via CAN communication from the spiral cable sub-assembly that indicates an internal malfunction.
DTC Code
DTC Detection Condition
Trouble Area
C1626
A fail flag is transmitted from the steering angle sensor.
  1. Spiral cable sub-assembly
  2. Navigation receiver assembly

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the navigation receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).


1. REPLACE SPIRAL CABLE SUB-ASSEMBLY
  1. Replace the spiral cable sub-assembly with a normally functioning one (Click here).


NEXT


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC C1626 is not output.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

END (SPIRAL CABLE SUB-ASSEMBLY IS DEFECTIVE)


← C1625 Open or Short in Steering Angle Sensor +B (from Aug 2014)C1626 Steering Angle Sensor Failure (from Aug 2014) →