C1626 Steering Angle Sensor Failure
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This DTC is stored if the navigation receiver assembly receives a signal via CAN communication from the spiral cable sub-assembly that indicates an internal malfunction.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1626 |
A fail flag is transmitted from the steering angle sensor. |
|
INSPECTION PROCEDURE
- NOTICE:
- When "System initializing" is displayed on the navigation receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
- When "System initializing" is displayed on the navigation receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
| 1. REPLACE SPIRAL CABLE SUB-ASSEMBLY |
Replace the spiral cable sub-assembly with a normally functioning one (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC C1626 is not output.
|
|
||||
| OK | ||
| ||
