2013-2015 Land Cruiser Prado · Service Manual Brake

C1436 Yaw Rate Sensor Malfunction

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

Refer to DTC C1419 and C1435 (Click here).
DTC Code
DTC Detection Condition
Trouble Area
C1436
Either condition is met:
  1. With the vehicle stationary, the yaw rate and acceleration sensor output value is not 0°/s.
  2. An abnormal comparison value.
Yaw rate and acceleration sensor

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 (Click here).

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the yaw rate and acceleration sensor, perform calibration (Click here).
  2. Check the yaw rate and acceleration sensor signal after replacement (Click here).

HINT:
When DTC U0123, U0124 and/or U0126 is output together with DTC C1436, inspect and repair the trouble areas indicated by DTC U0123, U0124 and/or U0126 first (Click here).


1. READ VALUE USING INTELLIGENT TESTER (YAW RATE SENSOR)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Yaw Rate Sensor
    Yaw rate and acceleration sensor 1 reading/ Min.: -128°/s, Max.: 127°/s
    Vehicle stationary: 0°/s
    Right turn: -128 to 0°/s
    Left turn: 0 to 127°/s
    -

  1. Check that the yaw rate and acceleration sensor output value is displayed on the intelligent tester.

    Result 
    Result
    Proceed to
    NG
    Yaw rate and acceleration sensor output value is 0°/s when vehicle is stationary, but value fluctuates when turning
    A
    Yaw rate and acceleration sensor output value is not 0°/s when vehicle is stationary
    B
    OK
    C



B
REPLACE YAW RATE AND ACCELERATION SENSOR (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A


2. CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION
  1. Turn the ignition switch off.

  1. Check that the yaw rate and acceleration sensor is installed properly (Click here).

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not installed at an angle.



NG
INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY (Click here)
OK

REPLACE YAW RATE AND ACCELERATION SENSOR (Click here)


← C1434 Steering Angle Sensor Output Malfunction (from Aug 2014)C1436 Yaw Rate Sensor Malfunction (from Aug 2014) →