DISASSEMBLY
Removal / installation · Vehicles built from Aug 2013
- NOTICE:
- When using a vise, do not overtighten it.
| 1. REMOVE TIE ROD END SUB-ASSEMBLY LH |
Put matchmarks on the tie rod end LH and steering rack end.

Text in Illustration *a
Matchmark
*b
Length A
Measure length A and record the measurement.
Remove the tie rod end LH.
| 2. REMOVE TIE ROD END SUB-ASSEMBLY RH |
- HINT:
- Use the same procedures described for the LH side.
| 3. REMOVE TURN PRESSURE TUBE |
Using a union nut wrench, remove the turn pressure tube LH and RH.

| 4. REMOVE STEERING GEAR OUTLET RETURN TUBE |
Using a union nut wrench, remove the return tube from the steering gear.

| 5. REMOVE STEERING RACK BOOT CLIP LH |
Using pliers, remove the steering rack boot clip.
| 6. REMOVE STEERING RACK BOOT CLIP RH |
- HINT:
- Use the same procedures described for the LH side.
| 7. REMOVE STEERING RACK BOOT CLAMP LH |
![]() ![]() |
Using pliers, remove the boot clamp as shown in the illustration.
- NOTICE:
- Be careful not to damage the steering rack boot.
| 8. REMOVE STEERING RACK BOOT CLAMP RH |
- HINT:
- Use the same procedures described for the LH side.
| 9. REMOVE NO. 2 STEERING RACK BOOT |
Remove the No. 2 steering rack boot.
| 10. REMOVE NO. 1 STEERING RACK BOOT |
Remove the No. 1 steering rack boot.
| 11. SECURE RACK AND PINION POWER STEERING GEAR ASSEMBLY |
Using SST, secure the steering gear assembly.

- SST
- 09612-00012
- HINT:
- Tape SST before use.
| 12. REMOVE STEERING RACK END SUB-ASSEMBLY |
Using SST, hold the steering rack (LH side).

- SST
- 09922-10010
Text in Illustration *A
LH Side
*B
RH Side
*a
Hold
*b
Turn
Using SST, remove the steering rack end (LH side) from the steering rack.
- SST
- 09922-10010
- HINT:
- Rotate SST in the direction shown in the illustration.
Using SST, remove the steering rack end (RH side) from the steering rack.
- SST
- 09922-10010
- HINT:
- Rotate SST in the direction shown in the illustration.
- NOTICE:
- Be sure to rotate SST in the correct direction.
- Be sure to keep the steering rack fixed in place with SST.
- Be sure to rotate SST in the correct direction.

