2013-2015 Land Cruiser Prado · Service Manual Steering

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

2. REMOVE FRONT WHEELS

3. REMOVE ENGINE ASSEMBLY
  1. for 1GR-FE:
    Remove the engine (Click here).

  1. for 1KD-FTV:
    Remove the engine (Click here).

  1. for 5L-E:
    Remove the engine (Click here).

  1. for 2TR-FE:
    Remove the engine (Click here).


4. DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT
  1. for Manual Tilt and Manual Telescopic Steering Column:
    Disconnect the No. 2 steering intermediate shaft (Click here).

  1. for Power Tilt and Power Telescopic Steering Column:
    Disconnect the No. 2 steering intermediate shaft (Click here).


5. DISCONNECT TIE ROD END SUB-ASSEMBLY LH

  1. C215754E01
    Using SST, disconnect the tie rod end assembly.
    SST
    09610-20012  


6. DISCONNECT TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


7. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for LHD)

  1. C215750
    Remove the clamp and disconnect the pressure feed tube (return tube side) from the steering gear.

  1. C215751
    Using a union nut wrench, disconnect the pressure feed tube (pressure feed tube side) from the steering gear.

  1. Remove the bolt and disconnect the pressure feed tube clamp.

    C215753E01

    Text in Illustration 
    *A
    for 1GR-FE:
    *B
    for 1KD-FTV:
    *C
    for 2TR-FE:
    *D
    for 5L-E:


8. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for RHD)

  1. C218256
    Remove the clamp and disconnect the pressure feed tube (return tube side) from the steering gear.

  1. C218257
    Using a union nut wrench, disconnect the pressure feed tube (pressure feed tube side) from the steering gear.

  1. Remove the bolt and disconnect the pressure feed tube clamp.

    C215752E01

    Text in Illustration 
    *A
    for 1GR-FE:
    *B
    for 1KD-FTV:
    *C
    for 2TR-FE:
    *D
    for 5L-E:


9. REMOVE RACK AND PINION POWER STEERING GEAR ASSEMBLY

  1. C215749
    Remove the 2 bolts, 2 nuts and steering gear assembly.

    NOTICE:
    Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut fixed in place.

← COMPONENTS (from Aug 2013)DISASSEMBLY (from Aug 2013) →