2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. INSTALL NO. 2 AMPLIFIER BRACKET
  1. Install the No. 2 amplifier bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


2. INSTALL NO. 1 AMPLIFIER BRACKET
  1. Install the No. 1 amplifier bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


3. INSTALL NO. 2 AMPLIFIER COVER

B359362E01
Text in Illustration 
*A
w/ Seat Heater System
*B
for JBL Made, w/o Seat Heater System
  1. w/ Seat Heater System:

    1. Install the No. 2 amplifier cover with the bolt and screw.

      Torque:
      for Bolt:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    2. Attach the clamp.

  1. for JBL Made, w/o Seat Heater System:

    1. Attach the 3 clips to install the No. 2 amplifier cover.


4. INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY

B359359E01
Text in Illustration 
*A
for Pioneer Made
*B
for JBL Made
*C
w/ Seat Heater System
*D
w/o Seat Heater System
  1. Attach the guide to install the stereo component amplifier assembly.

  1. Install the bolt and 2 screws.

    Torque:
    w/ Seat Heater System Bolt:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
    w/o Seat Heater System Bolt:
    4.5 N*m{ 46 kgf*cm , 40 in.*lbf }

  1. Connect each connector.


5. INSTALL AMPLIFIER COVER
  1. w/ Seat Heater System:

    1. Install the amplifier cover with the 3 clips.

  1. w/o Seat Heater System:

    1. Install the amplifier cover with the 3 screws and clip.

      Torque:
      3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

    2. Attach the clamp.

  1. Return the floor carpet to its original position.


6. INSTALL FRONT SEAT ASSEMBLY RH
  1. for Manual Seat Type:
    (Click here)

  1. for Power Seat Type:
    (Click here)

  1. for Walk in Seat Type:
    (Click here)

  1. for Bench Seat Type:
    (Click here)


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


8. CHECK SRS WARNING LIGHT
(Click here)
← REMOVAL (from Aug 2014)INSTALLATION (from Aug 2014) →