INSTALLATION
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. INSTALL NO. 2 AMPLIFIER BRACKET |
Install the No. 2 amplifier bracket with the 2 screws.
- Torque:
- 3.0 N*m{ 31 kgf*cm , 27 in.*lbf }
| 2. INSTALL NO. 1 AMPLIFIER BRACKET |
Install the No. 1 amplifier bracket with the 2 screws.
- Torque:
- 3.0 N*m{ 31 kgf*cm , 27 in.*lbf }
| 3. INSTALL NO. 2 AMPLIFIER COVER |


| *A |
w/ Seat Heater System |
*B |
for JBL Made, w/o Seat Heater System |
w/ Seat Heater System:
Install the No. 2 amplifier cover with the bolt and screw.
- Torque:
- for Bolt:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
Attach the clamp.
for JBL Made, w/o Seat Heater System:
Attach the 3 clips to install the No. 2 amplifier cover.
| 4. INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY |


| *A |
for Pioneer Made |
*B |
for JBL Made |
| *C |
w/ Seat Heater System |
*D |
w/o Seat Heater System |
Attach the guide to install the stereo component amplifier assembly.
Install the bolt and 2 screws.
- Torque:
- w/ Seat Heater System Bolt:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
- w/o Seat Heater System Bolt:
- 4.5 N*m{ 46 kgf*cm , 40 in.*lbf }
Connect each connector.
| 5. INSTALL AMPLIFIER COVER |
w/ Seat Heater System:
Install the amplifier cover with the 3 clips.
w/o Seat Heater System:
Install the amplifier cover with the 3 screws and clip.
- Torque:
- 3.0 N*m{ 31 kgf*cm , 27 in.*lbf }
Attach the clamp.
Return the floor carpet to its original position.
| 6. INSTALL FRONT SEAT ASSEMBLY RH |
for Manual Seat Type:
(Click here)
for Power Seat Type:
(Click here)
for Walk in Seat Type:
(Click here)
for Bench Seat Type:
(Click here)
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 8. CHECK SRS WARNING LIGHT |
