2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

Security Horn Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When the theft deterrent system is in the alarm sounding state, the main body ECU outputs a signal repeatedly at 0.4 second intervals, causing the security horn assembly to sound.

WIRING DIAGRAM

B184350E05

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY HORN)
  1. Operate the intelligent tester according to the steps on the display and select Active Test (Click here).

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Horn
    Security horn
    ON/OFF
    -

    OK:
    Security horn operates normally.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT S-HORN RELAY

  1. E145692E01
    Remove the S-HORN relay from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω



NG
REPLACE S-HORN RELAY
OK


3. INSPECT SECURITY HORN ASSEMBLY
  1. Remove the security horn (Click here).

  1. Apply battery voltage to the horn connector and check the operation of the horn.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Horn bracket
    Horn sounds



NG
REPLACE SECURITY HORN ASSEMBLY (Click here)
OK


4. CHECK HARNESS AND CONNECTOR (ENGINE ROOM RELAY BLOCK - MAIN BODY ECU AND SECURITY HORN)
  1. Remove the S-HORN relay from the engine room relay block.

  1. Remove the main body ECU (Click here).

  1. Disconnect the A26 horn connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Relay block S-HORN relay terminal 1 - A-17 (SH)
    Always
    Below 1 Ω
    Relay block S-HORN relay terminal 3 - A26-1
    Always
    Below 1 Ω
    A-17 (SH) - Body ground
    Always
    10 kΩ or higher
    A26-1 - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Relay block S-HORN relay terminal 2 - Body ground
    Always
    11 to 14 V
    Relay block S-HORN relay terminal 5 - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)


← Security Horn Circuit (Aug 2013 – Jul 2014)Intrusion Sensor Cancel Switch Circuit (Aug 2013 – Jul 2014) →