Intrusion Sensor Cancel Switch Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
- When the intrusion sensor OFF switch on the map light assembly is pressed, the sensor off signal is sent to the main body ECU which causes the theft warning radar sensor (intrusion sensor) to stop operating.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (INTRUSION SENSOR OFF SWITCH) |
Using the intelligent tester, read the Data List (Click here).
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Intrusion Sens OFF SW
Intrusion sensor OFF switch /
ON or OFF
ON: Intrusion sensor OFF switch pushed
OFF: Intrusion sensor OFF switch not pushed
-
- OK:
- ON (intrusion sensor OFF switch pushed) and OFF (intrusion sensor OFF switch not pushed) appear on screen according to switch condition.
|
|
||||
| OK | ||
| ||
| 2. INSPECT MAP LIGHT ASSEMBLY (INTRUSION SENSOR OFF SWITCH) |
Remove the map light (Click here).

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
5 (GND3) - 26 (SOFF)
Intrusion sensor OFF switch pushed
Below 1 Ω
5 (GND3) - 26 (SOFF)
Intrusion sensor OFF switch not pushed
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (MAP LIGHT - MAIN BODY ECU AND BODY GROUND) |
Disconnect the W7 light connector.
Disconnect the G64 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
W7-26 (SOFF) - G64-23 (SSW1)
Always
Below 1 Ω
W7-26 (SOFF) or G64-23 (SSW1) - Body ground
Always
10 kΩ or higher
W7-5 (GND3) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
