2013-2015 Land Cruiser Prado · Service Manual Brake

C1442 Invalid Data Received from Acceleration Sensor

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The skid control ECU receives signals from the acceleration sensor via the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
C1442
An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more.
Acceleration sensor

INSPECTION PROCEDURE

NOTICE:
When replacing the acceleration sensor, perform calibration (Click here).


1. CHECK DTC
  1. Turn the ignition switch off.

  1. Clear the DTCs (Click here).

  1. Start the engine and idle it for 60 seconds, and then stop the engine.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE ACCELERATION SENSOR (Click here)


← C1430 Brake Pedal Load Sensing Switch OFF Stuck Malfunction (+ C1431) (from Aug 2014)C1442 Invalid Data Received from Acceleration Sensor (from Aug 2014) →