2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

C214173E10
Text in Illustration 
*a
Component without harness connected
(Rear Height Control Sensor)
*b
Min. Low
*c
Normal
*d
Max. High
V100135
45°
V100136
45°
  1. Connect 3 dry batteries of 1.5 V in series.

  1. Connect the positive (+) end of the batteries to terminal 1 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 3 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 3 (SHG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2 (SHRR) - 3 (SHG)
    Max. high (45°)
    4.4 to 4.6 V
    Normal (0°)
    2.3 to 2.6 V
    Min. low (-45°)
    0.4 to 0.6 V

    NOTICE:
    Do not apply a voltage of 5 V or higher.

    If the result is not as specified, replace the rear height control sensor sub-assembly.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →