2013-2015 Land Cruiser Prado · Service Manual Suspension

C1789/89 Vehicle Identification Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

  1. This DTC is stored when the suspension control ECU is initialized and is cleared when the vehicle identification information received through CAN communication system is correctly stored in the EEPROM.
  2. DTC C1789/89 is stored when an incorrect ECM is installed as the vehicle specification and data do not match.
DTC Code
DTC Detection Condition
Trouble Area
C1789/89
Either condition is met:
  1. The vehicle identification information is not stored.
  2. The information stored in the suspension control ECU and the vehicle identification information received through CAN communication system do not match.
  1. Suspension control ECU
  2. ECM

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the suspension control ECU, perform registration (Click here).
  2. Do not exchange the suspension control ECU with a normally functioning one from another vehicle to perform troubleshooting.


1. PERFORM REGISTRATION
  1. Perform registration (Click here).


NEXT


2. CHECK FOR DTC
  1. Clear DTC (Click here).

  1. Check if DTC C1789/89 is output (Click here).

    OK:
    DTC C1789/89 is not output.



NG
Go to step 3
OK

END

3. CHECK PART NUMBER
  1. Check that the part number of the installed ECM is correct (for 1KD-FTV: Click here, for 1GR-FE: Click here).

    NOTICE:
    When removing the ECM to check the part number, or when replacing the ECM, be sure to follow the appropriate procedures and precautions.

    OK:
    ECM with correct part number is installed.

    Result
    Proceed to
    OK
    A
    NG (for 1KD-FTV)
    B
    NG (for 1GR-FE)
    C



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)
A


4. CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


5. CHECK FOR DTC
  1. Check if DTC C1789/89 is output (Click here).

    OK:
    DTC C1789/89 is not output.

    HINT:
    If no parts are replaced and DTC C1789/89 is output, there may be an internal malfunction in the suspension control ECU. In this case, replace the suspension control ECU.



NG
REPLACE SUSPENSION CONTROL ECU (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← C1789/89 Vehicle Identification Malfunction (Aug 2013 – Jul 2014)C1791/91 Adaptive Variable Suspension (AVS) Switch Circuit (Test Mode DTC) (Aug 2013 – Jul 2014) →