C1789/89 Vehicle Identification Malfunction
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
- This DTC is stored when the suspension control ECU is initialized and is cleared when the vehicle identification information received through CAN communication system is correctly stored in the EEPROM.
- DTC C1789/89 is stored when an incorrect ECM is installed as the vehicle specification and data do not match.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1789/89 |
Either condition is met:
|
|
INSPECTION PROCEDURE
- NOTICE:
- When replacing the suspension control ECU, perform registration (Click here).
- Do not exchange the suspension control ECU with a normally functioning one from another vehicle to perform troubleshooting.
- When replacing the suspension control ECU, perform registration (Click here).
| 1. PERFORM REGISTRATION |
Perform registration (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Clear DTC (Click here).
Check if DTC C1789/89 is output (Click here).
- OK:
- DTC C1789/89 is not output.
|
|
||||
| OK | ||
| ||
| 3. CHECK PART NUMBER |
Check that the part number of the installed ECM is correct (for 1KD-FTV: Click here, for 1GR-FE: Click here).
- NOTICE:
- When removing the ECM to check the part number, or when replacing the ECM, be sure to follow the appropriate procedures and precautions.
- OK:
- ECM with correct part number is installed.
Result
Proceed to
OK
A
NG (for 1KD-FTV)
B
NG (for 1GR-FE)
C
|
|
||||
|
|
||||
| A | |
| 4. CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 5. CHECK FOR DTC |
Check if DTC C1789/89 is output (Click here).
- OK:
- DTC C1789/89 is not output.
- HINT:
- If no parts are replaced and DTC C1789/89 is output, there may be an internal malfunction in the suspension control ECU. In this case, replace the suspension control ECU.
|
|
||||
| OK | ||
| ||
