HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the following procedures to troubleshoot the front power seat control system.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
|
 |
|
|
| 3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
for LHD:
Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).
for RHD:
Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).
Result
Result
|
Proceed to
|
CAN DTC is not output
|
A
|
CAN DTC is output (for LHD)
|
B
|
CAN DTC is output (for RHD)
|
C
|
Check for DTCs (Click here).
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
Result
Result
|
Proceed to
|
DTC is not output
|
A
|
DTC is output
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Refer to Problem Symptoms Table (Click here).
Result
Result
|
Proceed to
|
Fault is not listed in problem symptoms table
|
A
|
Fault is listed in problem symptoms table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Operation Check (Click here)
Data List / Active Test (Click here)
Terminals of ECU (Click here)
| NEXT |
|
 |
|
|
| 7.ADJUST, REPAIR OR REPLACE |
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|