2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH

  1. E282715E02
    Put protective tape around the rear combination light assembly LH.
    Text in Illustration 
    *1
    Protective Tape

  1. Connect the connector.

  1. Move the rear combination light assembly LH in the direction of the arrow in the illustration and attach the 4 clips to install the rear combination light assembly LH.

  1. Install the 2 bolts.

    E282566E02

    Text in Illustration 
    *A
    for LH Side
    *B
    for RH Side


2. INSTALL REAR BUMPER COVER
(Click here)
← REASSEMBLY (from Aug 2013)COMPONENTS (from Aug 2013) →