2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH
  1. Connect the connector.

  1. E201244
    Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow to connect it.

  1. Attach the 4 clamps to install the rear combination light socket and wire sub-assembly LH.


2. INSTALL BACK UP LIGHT BULB

  1. E282719
    Install the back up light bulb to the rear combination light socket and wire sub-assembly LH.

  1. E198137
    Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow to connect it.


3. INSTALL REAR TURN SIGNAL LIGHT BULB

  1. E282717
    Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly LH.

  1. E198138
    Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow to connect it.


4. INSTALL UPPER REAR BUMPER RETAINER LH
  1. Attach the 2 guides to install the upper rear bumper retainer LH.

← INSPECTION (from Aug 2013)INSTALLATION (from Aug 2013) →