2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE UPPER REAR BUMPER RETAINER LH

  1. E265515
    Detach the 2 guides and remove the upper rear bumper retainer LH.


2. REMOVE REAR TURN SIGNAL LIGHT BULB

  1. E198135
    Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow to disconnect it.

  1. E282716
    Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly LH.


3. REMOVE BACK UP LIGHT BULB

E198136
  1. Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow to disconnect it.

  1. E282718
    Remove the back up light bulb from the rear combination light socket and wire sub-assembly LH.


4. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH

  1. E281069
    Detach the 4 clamps.

  1. E201243
    Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow to disconnect it.

  1. E282720
    Disconnect the connector and remove the rear combination light socket and wire sub-assembly LH.

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2013) →