U0100 Lost Communication with ECM / PCM
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Also covers:
- U0129 Lost Communication with Brake System Control Module
- U0142 Lost Communication with Main Body ECU
- U0155 Lost Communication with Combination Meter
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The power management control ECU receives information from 2 sources. It receives information via a direct line and via the CAN communication line. If the information from these 2 sources is inconsistent, this DTC is stored.- HINT:
- When the power management control ECU is replaced with a new one and the cable is connected to the negative (-) battery terminal, the power source mode is reset to on (IG). When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| U0100 |
There is no communication from the ECM. |
|
| U0129 |
There is no communication from the skid control ECU. |
|
| U0142 |
There is no communication from the main body ECU. |
|
| U0155 |
There is no communication from the combination meter. |
|
INSPECTION PROCEDURE
| 1. CHECK FOR DTC |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
for LHD with Entry and Start System
B
for RHD with Entry and Start System
C
|
|
||||
|
|
||||
| A | ||
| ||
