2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

U0100 Lost Communication with ECM / PCM

Diagnostic trouble codes · Vehicles built from Aug 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The power management control ECU receives information from 2 sources. It receives information via a direct line and via the CAN communication line. If the information from these 2 sources is inconsistent, this DTC is stored.

HINT:
When the power management control ECU is replaced with a new one and the cable is connected to the negative (-) battery terminal, the power source mode is reset to on (IG). When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.

DTC Code
DTC Detection Condition
Trouble Area
U0100
There is no communication from the ECM.
  1. CAN communication system
  2. ECM
U0129
There is no communication from the skid control ECU.
  1. CAN communication system
  2. Skid control ECU
U0142
There is no communication from the main body ECU.
  1. CAN communication system
  2. Main body ECU (Driver side junction block assembly)
U0155
There is no communication from the combination meter.
  1. CAN communication system
  2. Combination meter assembly

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Check for DTCs and note any codes that are output (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    for LHD with Entry and Start System
    B
    for RHD with Entry and Start System
    C



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← U0100 Lost Communication with ECM / PCM (+ U0129, U0142, U0155) (Aug 2013 – Jul 2014)Engine does not Start (Aug 2013 – Jul 2014) →