2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

Distance Control Switch Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The distance control switch sets the vehicle-to-vehicle distance setting. The distance control switch is installed in the steering pad switch. The vehicle-to-vehicle distance setting can be changed by operating the distance control switch in the steering pad switch while the dynamic radar cruise control system is in operation.

WIRING DIAGRAM

E178428E03

INSPECTION PROCEDURE


1. INSPECT SPIRAL CABLE SUB-ASSEMBLY
  1. Remove the spiral cable sub-assembly (Click here).

  1. E181977E03
    If there are any defects as follows, replace the spiral cable with a new one: scratches, cracks, dents or chips in the connector or spiral cable.

  1. Check the spiral cable.

    1. Set the spiral cable to the center position (Click here).

    2. Rotate the spiral cable 2.5 times clockwise and measure the resistance according to the value(s) in the table below. Then rotate the spiral cable 5 times counterclockwise and measure the resistance according to the value(s) in the table below.

      NOTICE:
      As the spiral cable may break, do not rotate the spiral cable more than the specified amount.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      4 (DIST) - 11 (DIST)
      Always
      Below 1 Ω
      6 (ECC) - 2 (ECC)

    3. Set the spiral cable to the center position and rotate the spiral cable 2.5 times clockwise. Then, while rotating the spiral cable 5 times counterclockwise, measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      4 (DIST) - 11 (DIST)
      Always
      Below 1 Ω
      6 (ECC) - 2 (ECC)



NG
REPLACE SPIRAL CABLE SUB-ASSEMBLY (Click here)
OK


Go to step 3

2. INSPECT STEERING PAD SWITCH ASSEMBLY (DISTANCE CONTROL SWITCH)

  1. Remove the steering pad switch assembly (Click here).E192966E02

    Text in Illustration 
    *1
    Distance Control Switch
    -
    -

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 (DIST) - 6 (ECC)
    Distance control switch on
    Below 2.5 Ω
    Distance control switch off
    1 MΩ or higher



NG
REPLACE STEERING PAD SWITCH ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - DRIVING SUPPORT ECU AND BODY GROUND)
  1. Disconnect the G40 spiral cable connector.

  1. Disconnect the G119 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G40-11 (DIST) - G119-7 (MODE)
    Always
    Below 1 Ω
    G40-2 (ECC) - Body ground
    G40-11 (DIST) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Millimeter Wave Radar Sensor Power Source Circuit (from Aug 2014)Distance Control Switch Circuit (from Aug 2014) →