2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL SPIRAL CABLE SUB-ASSEMBLY
  1. Attach the 3 claws to install the spiral cable sub-assembly.

    CAUTION:
    When replacing the spiral cable sub-assembly with a new one, remove the lock pin before installing the steering wheel assembly.

  1. Connect the connectors to the spiral cable sub-assembly.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


2. INSTALL UPPER STEERING COLUMN COVER
  1. for Manual Tilt and Manual Telescopic Steering Column:

    1. Install the upper steering column cover (Click here).

  1. for Power Tilt and Power Telescopic Steering Column:

    1. Install the upper steering column cover (Click here).


3. INSTALL LOWER STEERING COLUMN COVER
  1. for Manual Tilt and Manual Telescopic Steering Column:

    1. Install the lower steering column cover (Click here).

  1. for Power Tilt and Power Telescopic Steering Column:

    1. Install the lower steering column cover (Click here).


4. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

5. ADJUST SPIRAL CABLE SUB-ASSEMBLY
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. B181594
    Rotate the spiral cable sub-assembly with steering sensor counterclockwise slowly by hand until it feels firm.

    CAUTION:
    Do not turn the spiral cable sub-assembly with steering sensor by the airbag wire harness.

  1. B359176E01
    Rotate the spiral cable sub-assembly with steering sensor clockwise approximately 2.5 turns to align the marks so that the colored part or the flat cable shown in the illustration is visible.
    Text in Illustration 
    *A
    w/o Steering Heater
    *B
    w/ Steering Heater
    *1
    Alignment Mark
    *2
    Colored Part
    *3
    Flat Cable

    CAUTION:
    Do not turn the spiral cable sub-assembly with steering sensor by the airbag wire harness.

    HINT:
    The spiral cable sub-assembly with steering sensor can be rotated approximately 2.5 turns to both the left and right from the center position.


6. INSTALL STEERING WHEEL ASSEMBLY
  1. Install the steering wheel assembly (Click here).

← INSPECTION (from Aug 2014)INSTALLATION (from Aug 2014) →