2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1612 IG Voltage is Low or High

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored if the parking assist ECU judges as a result of its self check that the voltage received by terminal IG is low or high.
DTC Code
DTC Detection Condition
Trouble Area
C1612
  1. IG voltage is low
  2. IG voltage is high
  1. Harness or connector
  2. Parking assist ECU

WIRING DIAGRAM

E182726E83

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the parking assist ECU after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
  3. Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC C1612 is not output.

    HINT:
    If the parking assist ECU cannot read the stored information when it is activated, allowing the ECU to store the information again may return the system to normal.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - BATTERY AND BODY GROUND)

  1. E245332E36
    Disconnect the parking assist ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I6-4 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I6-8 (IG) - I6-4 (GND1)
    Engine switch on (IG)
    10 to 16 V

Text in Illustration 
*a
Front view of wire harness connector
(to Parking Assist ECU)
Result 
Proceed to
Result
OK (for LHD)
A
OK (for RHD)
B
NG
C


B
REPLACE PARKING ASSIST ECU (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE PARKING ASSIST ECU (Click here)


← C1612 IG Voltage is Low or High (Aug 2013 – Jul 2014)C1613 ACC Voltage is Low or High (Aug 2013 – Jul 2014) →