Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
DESCRIPTION
This DTC is stored if the parking assist ECU judges as a result of its self check that the voltage received by terminal ACC is not normal.
DTC Code
DTC Detection Condition
Trouble Area
C1613
ACC voltage is low
ACC voltage is high
Harness or connector
Parking assist ECU
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When "System initializing" is displayed on the parking assist ECU after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
If the parking assist ECU cannot read the stored information when it is activated, allowing the ECU to store the information again may return the system to normal.