2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1694 Steering Angle Initialization Incomplete

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when the navigation receiver assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).
DTC Code
DTC Detection Condition
Trouble Area
C1694
Maximum steering angle has not been memorized
  1. Steering angle setting
  2. Navigation receiver assembly

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the navigation receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).


1. PERFORM SETTINGS (STEERING ANGLE SETTING)
  1. Perform the following procedure depending on the memory conditions to register the vehicle information into the navigation receiver assembly.

    1. Refer to steering angle setting (Click here).


NEXT


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC C1694 is not output.

    HINT:
    1. If DTC C1694 is output, perform the steering angle setting again.
    1. If DTC C1694 is still output after performing the steering angle setting 3 times, replace the navigation receiver assembly.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

END (SETTINGS ARE DEFECTIVE)


← C1694 Steering Angle Initialization Incomplete (Aug 2013 – Jul 2014)U0100 Lost Communication with ECM (+ U0126, U0129, U0140) (Aug 2013 – Jul 2014) →