2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Guide Lines and Buttons are not Displayed for All Display Modes

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The navigation receiver assembly receives back door open/close signals from the main body ECU (multiplex network body ECU) via CAN communication. When the back door is open, the camera aiming cannot be adjusted correctly because the rear television camera assembly is installed on the back door. Therefore, when performing back camera position setting while the back door is open, a back door open warning message will be displayed on the screen and back camera position setting will be canceled.

HINT:
Check the parking assist monitor screen display mode settings. (Check if the parking guide lines are set to off.)


WIRING DIAGRAM

E283804E01

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the navigation receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).


1. READ VALUE USING GTS
  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Main Body / Data List.

  1. Read the Data List according to the display on the GTS.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Back Door Courtesy SW
    Back door courtesy switch signal / ON or OFF
    ON: Back door open
    OFF: Back door closed
    -

    OK:
    The back door courtesy switch functions as specified in the normal condition column.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT BACK DOOR COURTESY LIGHT SWITCH ASSEMBLY
  1. Remove the back door courtesy light switch assembly (Click here).

  1. Inspect the back door courtesy light switch assembly (Click here).



NG
REPLACE BACK DOOR COURTESY LIGHT SWITCH ASSEMBLY (Click here)
OK


3. CHECK CHECK HARNESS AND CONNECTOR (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU] - BACK DOOR COURTESY LIGHT SWITCH ASSEMBLY)
  1. Disconnect the G64 main body ECU (multiplex network body ECU) connector.

  1. Disconnect the R9 back door courtesy light switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G64-19 (BCTY) - R9-1
    Always
    Below 1 Ω
    G64-19 (BCTY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)


← Image from Camera for Parking Assist Monitor is Abnormal (from Aug 2014)Guide Lines and Buttons are not Displayed for All Display Modes (from Aug 2014) →