Guide Lines and Buttons are not Displayed for All Display Modes
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The navigation receiver assembly receives back door open/close signals from the main body ECU (multiplex network body ECU) via CAN communication. When the back door is open, the camera aiming cannot be adjusted correctly because the rear television camera assembly is installed on the back door. Therefore, when performing back camera position setting while the back door is open, a back door open warning message will be displayed on the screen and back camera position setting will be canceled.- HINT:
- Check the parking assist monitor screen display mode settings. (Check if the parking guide lines are set to off.)
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When "System initializing" is displayed on the navigation receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
- When "System initializing" is displayed on the navigation receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
| 1. READ VALUE USING GTS |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Back Door Courtesy SW
Back door courtesy switch signal / ON or OFF
ON: Back door open
OFF: Back door closed
-
- OK:
- The back door courtesy switch functions as specified in the normal condition column.
|
|
||||
| OK | ||
| ||
| 2. INSPECT BACK DOOR COURTESY LIGHT SWITCH ASSEMBLY |
Remove the back door courtesy light switch assembly (Click here).
Inspect the back door courtesy light switch assembly (Click here).
|
|
||||
| OK | |
| 3. CHECK CHECK HARNESS AND CONNECTOR (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU] - BACK DOOR COURTESY LIGHT SWITCH ASSEMBLY) |
Disconnect the G64 main body ECU (multiplex network body ECU) connector.
Disconnect the R9 back door courtesy light switch assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G64-19 (BCTY) - R9-1
Always
Below 1 Ω
G64-19 (BCTY) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
