The parking assist ECU receives back door courtesy light switch assembly open/close signals from the main body ECU via CAN communication. When the back door is open, the camera aiming cannot be adjusted correctly because the rear television camera assembly is installed on the back door. Therefore, when adjusting the camera aiming calibration while the back door is open, a back door open warning message will be displayed on the screen and camera aiming adjustment will be canceled.
HINT:
The back door courtesy light switch assembly is connected to the main body ECU by the vehicle wire harness.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When "System initializing" is displayed on the navigation receiver assembly*1 or radio and display receiver assembly*2 after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
*1: for Navigation Receiver Type
*2: for Radio and Display Type
1. READ VALUE USING GTS (BACK DOOR COURTESY SWITCH)
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body / Main Body / Data List.
Check the Data List for proper functioning of the following item.
Main Body
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Back Door Courtesy SW
Back door courtesy switch signal/ON or OFF
ON: Back door open OFF: Back door closed
-
OK:
The back door courtesy switch functions as specified in the normal condition column.