General
Symptom
|
Suspected Area
|
See page
|
When the shift lever is in R, the parking assist monitor image is not displayed (screen is not black).
|
CAN communication system
|
Click here
|
Proceed to "Navigation Receiver Assembly Power Source Circuit"
|
Click here
|
Navigation receiver assembly
|
Click here
|
When the shift lever is in R, the parking assist monitor image is not displayed (screen is black).
|
Proceed to "Image from Camera for Parking Assist Monitor is Abnormal"
|
Click here
|
Navigation receiver assembly
|
Click here
|
When the shift lever is not in R, the parking assist monitor image is displayed.
|
CAN communication system
|
Click here
|
Navigation receiver assembly
|
Click here
|
Parking Assist Monitor System Malfunction
Symptom
|
Suspected Area
|
See page
|
Estimated course lines are not displayed
|
Parking assist monitor screen display mode settings (Check that estimated course line display mode is selected)
|
Click here
|
Navigation receiver assembly
|
Click here
|
"System initializing" is displayed.
|
Correct the steering angle neutral point (Initialization)
|
Click here
|
"System initializing" is displayed even after correcting the steering angle neutral point.
|
Spiral cable sub-assembly
|
Click here
|
Correct the steering angle neutral point (Initialization)
|
Click here
|
Steering angle setting (Calibration)
|
Click here
|
Navigation receiver assembly
|
Click here
|
"System not ready" is displayed.
|
Parking assist monitor system initialization (Calibration)
|
Click here
|
"System not ready" is displayed even after Navigation receiver assembly initialization.
|
Navigation receiver assembly
|
Click here
|
During parallel parking assist mode, the screen does not change even though the vehicle has moved.
|
If the vehicle is driven in reverse at very low speed, the screen may not change
|
-
|
During parallel parking assist mode, the screen changes even though the vehicle has not moved.
|
If the vehicle is stopped for extended period of time, the screen may change
|
-
|
Guide lines and buttons are not displayed for all parking assist monitor screen display modes.
|
Proceed to "Guide Lines and Buttons are not Displayed for All Display Modes"
|
Click here
|
Main body ECU (multiplex network body ECU)
|
Click here
|
Navigation receiver assembly
|
Click here
|
The guide lines and buttons remain displayed even though the luggage compartment door is open.
|
CAN communication system
|
Click here
|
Proceed to "Guide Lines and Buttons are not Displayed for All Display Modes"
|
Click here
|
Main body ECU (multiplex network body ECU)
|
Click here
|
Navigation receiver assembly
|
Click here
|
When adjusting the camera optical axis, "Back door is open. Do not use the rear view monitor when the back door is not completely closed." is displayed even after the luggage compartment door has been closed.
|
Proceed to "Guide Lines and Buttons are not Displayed for All Display Modes"
|
Click here
|
Main body ECU (multiplex network body ECU)
|
Click here
|
Navigation receiver assembly
|
Click here
|
"CHK" message(s) are displayed on the "Car Signal Check" screen.
|
Car signal check (Diagnosis)
|
Click here
|
When the parking assist monitor screen is displayed, the lines are misaligned. (The image from the camera is tilted.)
|
Back camera position setting (Calibration)
|
Click here
|