HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the following procedures to troubleshoot the pre-crash safety system.
- *: Use the intelligent tester.
- Use the following procedures to troubleshoot the pre-crash safety system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK CAN COMMUNICATION SYSTEM* |
Using the intelligent tester, check if the CAN communication system is functioning normally.
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output (for LHD with Entry and Start System)
B
CAN DTC is output (for LHD without Entry and Start System)
C
CAN DTC is output (for RHD with Entry and Start System)
D
CAN DTC is output (for RHD without Entry and Start System)
E
|
|||||
|
|||||
|
|||||
|
|||||
| |||||
| 4.CHECK FOR DTC* |
Check for DTCs (Click here).
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here).
Data List / Active Test (Click here).
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
- NOTICE:
- When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed (Click here).
| |||||
| 8.CONFIRMATION TEST |
| |||||