PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| "CHECK PCS SYSTEM" is displayed |
Seat belt control ECU |
Click here
|
| "PCS TEMPORARILY NOT AVAILABLE" is displayed |
System determines obstacles cannot be detected due to millimeter wave radar sensor assembly or radiator grille being dirty. If dirt is removed, normal control returns (dirt history can be checked using Data List). |
Click here
|
| System determines millimeter wave radar sensor assembly cannot detect obstacles due to bad weather. If weather recovers, normal control returns (bad weather history can be checked using Data List). |
Click here
|
|
| Overheating prevention function of seat belt control ECU or millimeter wave radar sensor assembly operates. If ECU temperature drops, normal control returns. |
- |
|
| Pre-crash brake cancel switch circuit |
Click here
|
|
| Millimeter wave radar sensor assembly |
Click here
|
|
| Seat belt control ECU |
Click here
|
|
| Driving support ECU |
Click here
|
|
| Although there is possibility of collision, pre-crash control (all front collision controls) does not operate ("PCS TEMPORARILY NOT AVAILABLE" is not displayed) |
Vehicle condition/environment does not match pre-crash control operation conditions (confirm control operation conditions) |
Click here
|
| Check installation condition of millimeter wave radar sensor assembly |
Click here
|
|
| Perform millimeter wave radar sensor assembly adjustment |
Click here
|
|
| Millimeter wave radar sensor assembly |
Click here
|
|
| Driving support ECU |
Click here
|
|
| Although there is no possibility of collision, pre-crash control (all front collision controls) operates |
Vehicle condition/environment match pre-crash control operation conditions (confirm control operation conditions) |
Click here
|
| Check millimeter wave radar sensor assembly |
Click here
|
|
| Perform millimeter wave radar sensor assembly adjustment |
Click here
|
|
| Millimeter wave radar sensor assembly |
Click here
|
|
| Driving support ECU |
Click here
|
|
| Only pre-crash seat belt does not operate |
Buckle switch error (malfunction in which DTC is not output) |
- |
| Seat belt control ECU |
Click here
|
|
| Pre-crash brake cannot be canceled (pre-crash safety warning indicator does not illuminate) |
Combination meter assembly (check if indicator blinks using Active Test) |
Click here
|
| Pre-crash brake cancel switch circuit |
Click here
|
|
| Driving support ECU |
Click here
|